The German HBM PW6DC3MR single point weighing sensor is suitable for high dynamic industrial weighing applications

　　PW6DLoad CellyesGerman HBMofSingle point weighing sensorOne of the models, the complete model is PW6DC3MR, made of aluminum, capable of achieving dynamic and static weighing, mainly in small ranges, with a range of 3kg-40kg, high stiffness, and high measurement accuracy.

The accuracy level of PW6D reaches C3 MR (multi range), which is more accurate than C3 and has a protection level of IP67. Therefore, it has the advantages of high measurement accuracy, strong anti-interference ability, and accurate results.

In addition to accuracy, the PW6D single point weighing sensor also has extremely high speed and can withstand dynamic loads of up to 40kg. The PW6D single point weighing sensor has been optimized for dynamic applications, with extremely high stiffness and very small rated deformation. Therefore, it has a very high basic frequency and is very suitable for high dynamic industrial weighing applications.
　

The following is a specific introduction to the characteristics and advantages of PW6D weighing sensors:

1. High measurement accuracy, strong anti-interference ability, and accurate results

(1) High precision measurement results

(2) Accurate weighing, accuracy level C3 MR (multi range)

(3) 6-wire system, stable signal, less affected by temperature and cable length

(4) Use& Ldquo; Modco& Rdquo; Strain gauge, higher output signal

(5) Eccentric load compensation (OIML R76)

(6) Use shielded cables to ensure high electromagnetic compatibility

2. Measure the high stiffness and basic frequency of the body, with high weighing speed.

(1) High stiffness, suitable for rapid weighing

(2) Very small rated deformation, from 0.18 mm to 0.29 mm (depending on the rated range)

(3) Basic frequency up to 790 Hz

(4) Scale platform size up to 300 mm x 300 mm

(5) Size meets industry standards

4. Cable length and signal output can be configured

(1) 7 rated ranges (3 kg, 5 kg, 10 kg, 15 kg, 20 kg, 30 kg, 40 kg)

(2) Provide cable lengths ranging from 0.35 m to 6 m

(3) 6-wire connection, cable can be cut and used

(4) Adjustable output can be used for parallel connection

(5) Minimal calibration graduation (Vmin)