Safety instructions for using sensor junction boxes

　　1、Junction boxOnly used for interconnection interfaces, power supplies, and bus terminals. Any use other than the above shall be deemed not to comply with the provisions of this Regulation.

2. For safety reasons, the junction box can only be used according to the instructions in the installation instructions. During use, it is also necessary to comply with the relevant legal and safety requirements of the application. This also applies to the use of attachments.

3. The junction box is not& Ldquo; Use& appropriately; Rdquo; The safety components defined in.

4. For safe and trouble-free operation, the junction box must not only be transported, stored, positioned, and installed correctly, but also be carefully operated and maintained.

5. The junction box is an advanced device with automatic fault prevention performance. However, if untrained personnel install and operate improperly, the junction box may pose further hazards.

6. Any personnel instructed to install, debug, maintain or repair the junction box must read and understand the installation instructions, especially the technical safety instructions.

7. Unauthorized conversion and modification are prohibited. Unless we explicitly agree, the junction box shall not be modified from a design or safety engineering perspective. Any modification does not include our full responsibility for any damage caused thereby.

8. The protection level of junction boxes is usually relatively low, such as IP65 (dust proof, water spray proof). If it does not have a high level of protection, regular inspections must be carried out to ensure that the rubber seals in the cover and threaded joints are not leaking.