Safety instructions for using German HBM amplifiers

1. The use of German HBM amplifiers, as long as the instructions and instructions for project planning, assembly, proper operation, and maintenance are followed, usually do not pose any hazards related to the product.

2. It is necessary to comply with the safety and accident prevention regulations applicable to each individual case.

3. Installation and start-up must be carried out by qualified personnel.

4. Do not let the equipment get dirty or damp.
　

5. During the installation of the German HBM amplifier and when connecting cables, measures should be taken to prevent electrostatic discharge, as it may damage electronic equipment.

6. The power supply required for the German HBM amplifier is ultra-low voltage (5… 10 V), which can safely disconnect the power supply.

7. When connecting other equipment, safety requirements for electrical measurement, control, supervision, and laboratory equipment should be followed.

8. All interconnecting cables must be shielded cables. Both sides of the screen must be widely grounded. Shielding of power and digital I/O connection cables is only required when the cable length exceeds 30 meters (32.81 yards) or when laid outside enclosed buildings.

　　9、German HBMAfter the amplifier is powered on, a warm-up time of 15 minutes is required.

10. If the malfunction of the amplifier may cause significant damage, data loss, and even endanger personal safety, the factory must take additional safety precautions. When a malfunction occurs, these preventive measures must establish safe operating conditions.