Wiring instructions for weighing modules, junction boxes, and weighing instruments

A complete weighing system consists of three or four equal weighing modules (mainlyThe weighing sensor, junction box, and weighing display instrument are connected through wires. The following mainly introduces the wiring of the gray wire sensor.

1、 The weighing module is shown in the figure, and the sensor has five wires of different colors, namely:

2. Connect the sensor wires of the weighing module to the contacts of the CELL on the circuit board of the junction box according to the color represented in the above table. INDICATOR uses six core wires to connect to the weighing instrument;

3. When using six core wires in the junction box INDICATOR, connect one end according to the following table;
　 　 　 　 　　

4. The connection between the other end of the six core wire and the weighing instrument should correspond in sequence according to the color of one end of the safety barrier. The left end is connected to a 24V power supply (blue+gray), with a safety barrier in the middle and 4 on the right; Flash; 20MA (red+blue) current output;