PGR MB weighing module, available in the range of 1T to 470T from the US Zhongkessel brand

1、 Product Introduction of PGR MB Weighing Module from the US ZXSCELL Brand

Product brand:ZXSCELL in the United States ZXSCELL

Product series:PGR MB

Product Type:Weighing Module

Product Range: 1T, 2.2T, 3.3T, 4.7T, 10T, 15T, 22T, 33T, 47T, 68T, 100T, 150T, 220T, 330T, 470T

Product Introduction: The PGR MB weighing module is compatible with ZXSCELL's GDxN Series weighing sensors, with a rated range of up to 470 tons, for C3 level precise weighing The module has anti overturning protection and anti overload protection

Product features:

(1) Alloy steel material with nickel plating on the surface

(2) Using GDxN sensors

(3) Suitable for hopper scales, storage scales, and tank scales, etc

(4) Protection level IP67

(5) Easy installation and easy maintenance

二、美国中克塞尔品牌 PGR MB称重模块图片

三、PGR MB称重模块产品型号

PGR MB 1t

PGR MB 2.2t

PGR MB 3.3t

PGR MB 4.7t

PGR MB 10t

PGR MB 15t

PGR MB 22t

PGR MB 33t

PGR MB 47t

PGR MB 68t

PGR MB 100t

PGR MB 150t

PGR MB 220t

PGR MB 330t

PGR MB 470t

四、称重模块现场安装注意事项

Before installation, please check the foundation condition. Each installation point plane is perpendicular to the stress surface, and the levelness of the same foundation surface should be controlled within 1mm/m. The foundation bearing capacity should be greater than the range of the sensor

1) Before installing the module, please adjust the sensor and upper board to a horizontal state;

2) After the module installation is completed, please adjust the limit properly;

3) The pendulum support is mainly used to prevent equipment from overturning and is not used for weighing and measuring. It has a certain gap with the bearing plate and the pendulum support nut is locked tightly;

4) Cable color code (conventional sensor wire code, mainly based on certificate of conformity wire code)

Note: During equipment debugging, if there is a large angle difference, poor instrument return to zero, or a small or no change in weight value after weight loading, please check if the module limit part is stuck or slightly affected by friction; Check the peripheral hardware connections of the device for external forces, such as the impact of dead connections in pipelines on weighing