SWB CS static load weighing module, available in the range of 100kg to 5T from Kessel brand in the United States

1、 Product Introduction of SWB CS Weighing Module from the US ZXSCELL Brand

Product brand:ZXSCELL in the United States ZXSCELL

Product series:SWB CS

Product Type:Weighing Module Static load weighing module

Product Range: 100kg, 200kg, 250kg, 300kg, 500kg, 1T, 2T, 2.5T, 3T, 5T

Product Introduction: The SWB CS static load weighing module is compatible with ZXSCELL's SLBC series cantilever load cell, with a rated range of 100kg to 2T, which can help customers easily meet the weighing needs of various equipment such as storage tanks and ingredient tanks The equipment can achieve precise weight control by applying the SWB CS weighing module

Product features:

(1) Alloy steel material with nickel plating on the surface

(2) Using SLBC sensors

(3) Support bolts to prevent equipment from overturning

(4) Spherical connector, maintain vertical weighing state

(5) Suitable for electronic platform scales, mixing plants, and ingredient scales, etc

二、美国中克塞尔品牌 SWB CS称重模块图片

三、SWB CS称重模块产品型号

SWB CS 100kg

SWB CS 200kg

SWB CS 250kg

SWB CS 300kg

SWB CS 500kg

SWB CS 1t

SWB CS 2t

SWB CS 2.5t

SWB CS 3t

SWB CS 5t

四、称重模块现场安装注意事项

Before installation, please check the foundation condition. Each installation point plane is perpendicular to the stress surface, and the levelness of the same foundation surface should be controlled within 1mm/m. The foundation bearing capacity should be greater than the range of the sensor

1) Before installing the module, please adjust the sensor and upper board to a horizontal state;

2) After the module installation is completed, please adjust the limit properly;

3) The pendulum support is mainly used to prevent equipment from overturning and is not used for weighing and measuring. It has a certain gap with the bearing plate and the pendulum support nut is locked tightly;

4) Cable color code (conventional sensor wire code, mainly based on certificate of conformity wire code)

Note: During equipment debugging, if there is a large angle difference, poor instrument return to zero, or a small or no change in weight value after weight loading, please check if the module limit part is stuck or slightly affected by friction; Check the peripheral hardware connections of the device for external forces, such as the impact of dead connections in pipelines on weighing