SMM MK alloy steel weighing module can be selected as stainless steel, with a range of 100kg to 2T from the American Zhongkessel brand

1、 Product Introduction of SMM MK Weighing Module from the US ZXSCELL Brand

Product brand:ZXSCELL in the United States ZXSCELL

Product series:SMM MK

Product Type:Weighing Module

Product Range: 100kg, 150kg, 200kg, 250kg, 300kg, 500kg, 1T, 1.5T, 2T

Product Introduction: The SMM MK weighing module is compatible with ZXSCELL's SLBH series cantilever load cell, with a rated range of 100kg to 2T. It has a self reset function and anti overturning protection, and is suitable for static or dynamic load equipment with stirring The device can achieve precise weight control by applying the SMM MK weighing module

Product features:

(1) Alloy steel material, nickel plated surface, optional stainless steel material

(2) Using SLBH sensors

(3) Self reset function, anti overturning protection

(4) Suitable for both dynamic and static weighing applications

(5) Suitable for electronic platform scales, mixing plants, and ingredient scales, etc

二、美国中克塞尔品牌 SMM MK称重模块图片

三、SMM MK称重模块产品型号

SMM MK 100kg

SMM MK 150kg

SMM MK 200kg

SMM MK 250kg

SMM MK 300kg

SMM MK 500kg

SMM MK 1t

SMM MK 1.5t

SMM MK 2t

四、称重模块现场安装注意事项

Before installation, please check the foundation condition. Each installation point plane is perpendicular to the stress surface, and the levelness of the same foundation surface should be controlled within 1mm/m. The foundation bearing capacity should be greater than the range of the sensor

1) Before installing the module, please adjust the sensor and upper board to a horizontal state;

2) After the module installation is completed, please adjust the limit properly;

3) The pendulum support is mainly used to prevent equipment from overturning and is not used for weighing and measuring. It has a certain gap with the bearing plate and the pendulum support nut is locked tightly;

4) Cable color code (conventional sensor wire code, mainly based on certificate of conformity wire code)

Note: During equipment debugging, if there is a large angle difference, poor instrument return to zero, or a small or no change in weight value after weight loading, please check if the module limit part is stuck or slightly affected by friction; Check the peripheral hardware connections of the device for external forces, such as the impact of dead connections in pipelines on weighing