UW MK weighing module paired with corrugated tube sensor, available in the range of 10kg to 500kg from the US Zhongkessel brand

1、 Product Introduction of the UW MK Weighing Module of the US ZXSCELL Brand

Product brand:ZXSCELL in the United States ZXSCELL

Product series:UW MK

Product Type:Weighing Module Static load weighing module

Product Range: 10kg, 20kg, 30kg, 50kg, 100kg, 150kg, 200kg, 250kg, 300kg, 500kg

Product Introduction: The UW MK weighing module is compatible with ZXSCELL's BHxA series corrugated pipe load cell, which is sturdy and durable, with a rated range of up to 500KG, ensuring the stability of the storage tank and silo The UW MK weighing module has support bolts to prevent equipment overturning and ensure more accurate weight loading

Product features:

(1) Alloy steel material with nickel plating on the surface

(2) Using BHxA sensors

(3) Support bolts to prevent equipment from overturning

(4) Spherical connector, maintain vertical weighing state

(5) Protection level IP68

(6) Suitable for belt scales, filling scales, ingredient scales, etc

二、美国中克塞尔品牌 UW MK称重模块图片

三、UW MK称重模块产品型号

UW MK 10kg

UW MK 20kg

UW MK 30kg

UW MK 50kg

UW MK 100kg

UW MK 150kg

UW MK 200kg

UW MK 250kg

UW MK 300kg

UW MK 500kg

四、称重模块现场安装注意事项

Before installation, please check the foundation condition. Each installation point plane is perpendicular to the stress surface, and the levelness of the same foundation surface should be controlled within 1mm/m. The foundation bearing capacity should be greater than the range of the sensor

1) Before installing the module, please adjust the sensor and upper board to a horizontal state;

2) After the module installation is completed, please adjust the limit properly;

3) The pendulum support is mainly used to prevent equipment from overturning and is not used for weighing and measuring. It has a certain gap with the bearing plate and the pendulum support nut is locked tightly;

4) Cable color code (conventional sensor wire code, mainly based on certificate of conformity wire code)

Note: During equipment debugging, if there is a large angle difference, poor instrument return to zero, or a small or no change in weight value after weight loading, please check if the module limit part is stuck or slightly affected by friction; Check the peripheral hardware connections of the device for external forces, such as the impact of dead connections in pipelines on weighing