UW BM alloy steel weighing module, available in the range of 5kg to 500kg from the US Zhongkessel brand

1、 Product Introduction of UW BM Weighing Module from the US ZXSCELL Brand

Product brand:ZXSCELL in the United States ZXSCELL

Product series:UW BM

Product Type:Weighing Module

Product Range: 5kg, 10kg, 20kg, 30kg, 50kg, 100kg, 200kg, 250kg, 300kg, 500kg

Product Introduction: The UW BM weighing module is compatible with ZXSCELL's BHxR series corrugated pipe load cell, with a rated range of 5kg to 500T, allowing for more stable and accurate data during weighing The UW BM weighing module uses spherical connectors to maintain a vertical weighing state, making product ingredients more accurate and reducing raw material waste

Product features:

(1) Alloy steel material with nickel plating on the surface

(2) Using BHxR sensors

(3) Support bolts to prevent equipment from overturning

(4) Spherical connector, maintain vertical weighing state

(5) Protection level IP68

(6) Suitable for belt scales, filling scales, ingredient scales, etc

二、美国中克塞尔品牌 UW BM称重模块图片

三、UW BM称重模块产品型号

UW BM 5kg

UW BM 10kg

UW BM 20kg

UW BM 30kg

UW BM 50kg

UW BM 100kg

UW BM 200kg

UW BM 250kg

UW BM 300kg

UW BM 500kg

四、称重模块现场安装注意事项

Before installation, please check the foundation condition. Each installation point plane is perpendicular to the stress surface, and the levelness of the same foundation surface should be controlled within 1mm/m. The foundation bearing capacity should be greater than the range of the sensor

1) Before installing the module, please adjust the sensor and upper board to a horizontal state;

2) After the module installation is completed, please adjust the limit properly;

3) The pendulum support is mainly used to prevent equipment from overturning and is not used for weighing and measuring. It has a certain gap with the bearing plate and the pendulum support nut is locked tightly;

4) Cable color code (conventional sensor wire code, mainly based on certificate of conformity wire code)

Note: During equipment debugging, if there is a large angle difference, poor instrument return to zero, or a small or no change in weight value after weight loading, please check if the module limit part is stuck or slightly affected by friction; Check the peripheral hardware connections of the device for external forces, such as the impact of dead connections in pipelines on weighing