SWB MK alloy steel weighing module, available in the range of 100kg to 5T from the American Kessel brand

1、 Product Introduction of SWB MK Weighing Module from the US ZXSCELL Brand

Product brand:ZXSCELL in the United States ZXSCELL

Product series:SWB MK

Product Type:Weighing Module Static load weighing module

Product Range: 100kg, 150kg, 200kg, 250kg, 300kg, 500kg, 1T, 1.5T, 2T, 2.5T, 3T, 5T

Product Introduction: The SWB MK static load weighing module is compatible with ZXSCELL's SLBH series cantilever load cell, with a rated range of 100kg to 5T The powerful structural components of the SWB MK weighing module provide comprehensive protection for the equipment

Product features:

(1) Alloy steel material, nickel plated surface, optional stainless steel material

(2) Using SLBH sensors

(3) Support bolts to prevent equipment from overturning

(4) Spherical connector, maintain vertical weighing state

(5) Suitable for electronic platform scales, mixing plants, and ingredient scales, etc

二、美国中克塞尔品牌 SWB MK称重模块图片

三、SWB MK称重模块产品型号

SWB MK 100kg

SWB MK 150kg

SWB MK 200kg

SWB MK 250kg

SWB MK 300kg

SWB MK 500kg

SWB MK 1t

SWB MK 1.5t

SWB MK 2t

SWB MK 2.5t

SWB MK 3t

SWB MK 5t

四、称重模块现场安装注意事项

Before installation, please check the foundation condition. Each installation point plane is perpendicular to the stress surface, and the levelness of the same foundation surface should be controlled within 1mm/m. The foundation bearing capacity should be greater than the range of the sensor

1) Before installing the module, please adjust the sensor and upper board to a horizontal state;

2) After the module installation is completed, please adjust the limit properly;

3) The pendulum support is mainly used to prevent equipment from overturning and is not used for weighing and measuring. It has a certain gap with the bearing plate and the pendulum support nut is locked tightly;

4) Cable color code (conventional sensor wire code, mainly based on certificate of conformity wire code)

Note: During equipment debugging, if there is a large angle difference, poor instrument return to zero, or a small or no change in weight value after weight loading, please check if the module limit part is stuck or slightly affected by friction; Check the peripheral hardware connections of the device for external forces, such as the impact of dead connections in pipelines on weighing