【 Sense ZFA Sensor 】 ZFA-25kg~ZFA-5000kg_ France Scaime Weighing Sensor

Application: silo scale, tank or reactor weighing, mixer or filter weighing

Rated range (kg) 25…5000

accuracy C3

Sensitivity (mV/V) 3 ± 0.5%

material steel

certification Ex，NTEP，OIML，FM

Product structure dimensions:



Product Technical Parameters:



Expand Reading

weighing moduleInstallation Instructions
　Mechanical Installation　
If necessary, shims can be used to adjust the force evenly applied to each sensor.
The top and bottom plates of the weighing module must be adjusted in a straight line to maintain the vertical direction of the force acting on the sensor.
When welding near the weighing module, be sure to pay attention to grounding, otherwise the welding current will pass through the sensor and cause damage.
The basic requirements are horizontal and have good rigidity, with minimal differences in levelness between each foundation.
Be sure to tighten the support bolts of the weighing module during installation.
The weighing module must be installed in a convenient location for maintenance.
　connect the dots
All connections should use shielded insulated cables.
Electromagnetic interference can affect the output signal of sensors and cause weighing errors.
Isolate the power cord and sensor cable.
The junction box should be protected to prevent moisture and corrosive substances from corroding it.
Cables can be fitted with sleeves to prevent mechanical damage or corrosion from moisture and corrosive substances.
Do not arbitrarily change the length of the sensor cable, as this will alter the output impedance of the sensor.
It is recommended to use the recommended length and size for the connecting cable between the junction box and the weighing instrument, otherwise it may cause signal loss
　Preparation before calibration　
Install brackets on the tank to suspend weights. The spacing between each bracket should be equal.
Before calibration, the output signal of each sensor should be tested to determine whether the force is evenly distributed to each sensor
If necessary, shims can be used to adjust the level of the module or adjust the potentiometer of the junction box to keep the output of each sensor consistent.

The above is the detailed information of the [Shigan ZFA Sensor] ZFA-25kg~ZFA-5000kg_ France Scaime Weighing Sensor. If you have any questions about the price, delivery time, model, and inventory of the [Shigan ZFA Sensor] ZFA-25kg~ZFA-5000kg_ France Scaime Weighing Sensor, please feel free to call18520271262 Mr. ChenGet the latest price details of the ZFA-25kg~ZFA-5000kg_Sagime weighing sensor from France.