The American Shiquan PSD-SJTT spoke type weighing sensor is suitable for experimental machines and various force measurements

The PSD-SJTT model isAmerican ShiquanA Celtron brandSpoke type weighing sensorThere are different versions of loading holes belonging to the PSD model, in addition to the PSD-SJTH model version. The number, size, size, and distribution of loading holes vary among the three load cell models, and are usually used for experimental machines and various force measurements.

　　PSD-SJTTLoad CellThe material is alloy steel without electrolytic nickel plating (the 200kg range is made of aluminum alloy material), with a low cross-section and compact design. It has eccentric loading compensation, high output and small deformation, and the range can be selected from 200kg to 30t. The specific model is shown at the end of the article.
　

Even for the same model, the size and shape, groove, and loading hole size of the PSD-SJTT vary between different ranges. There are only four loading holes in the 200kg range, and the size of the loading holes is small; The 500kg and 1T ranges have eight loading holes and a groove in the middle of the sensor; The 1.5T and 2.5T ranges also have eight loading holes, but there is no groove in the middle of the sensor; The 5T and 10T ranges have eight loading holes with larger sizes; The size of the eight loading holes for the 25T and 30T ranges is larger than that of the 10T range.

In addition, PSD-SJTT also offers two models, PSD-50tSJTT and PSD-100tSJTT, with 16 loading holes and large loading hole sizes.

All models of PSD-SJTT weighing sensors from the United States are as follows:

　　PSD-200kgSJTT

　　PSD-500kgSJTT

　　PSD-1tSJTT

　　PSD-1.5tSJTT

　　PSD-2.5tSJTT

　　PSD-5tSJTT

　　PSD-10tSJTT

　　PSD-20tSJTT

　　PSD-25tSJTT

　　PSD-30tSJTT

　　PSD-50tSJTT

　　PSD-100tSJTT